Crypto Officer Guidance - Lexmark 10G0149 - PrintCryption Card Encryption Module Manual

Fips 140-2 non-proprietary security policy
Hide thumbs Also See for 10G0149 - PrintCryption Card Encryption Module:
Table of Contents

Advertisement

4. Print a menu settings page. If the new card is not listed under Printer
5. Launch the CD to host PC to install the software application using
6. Print a menu settings page. Compare these settings to those on the page
7. Place the Option Added label on the printer next to the printer model and

Crypto Officer Guidance

The Crypto Officer is responsible for installing, uninstalling and monitoring the
module. The card comes in a static sensitive package. Upon receiving the
PrintCryption card, the Crypto Officer should check for any signs of tampering to
the package, including a damaged seal or package.
The Crypto Officer may follow the installation sheet found in the option kit to
install the PrintCryption module. After the installation is complete, the Crypto
Officer must print a Menu page and verify that Optional Firmware Card is
displayed under the Installed Features section of the Menu Page.
The Crypto Officer must configure the printer onto the TCP/IP network per
installation requirements. While installing the PrintCryption host software
application on a PC, Crypto Officer must choose port 9150 to communicate with
the printer. It is recommended that Crypto Officer name the port "FIPS" to clearly
distinguish the port that provides secured printing service.
© Copyright 2006 Lexmark International Inc.
This document may be freely reproduced and distributed whole and intact including this Copyright Notice.
b. If the printer displays the message Resetting all of NVRAM for
longer than 45 seconds, turn off the printer and reinstall the card.
Information, turn off the printer and repeat steps 2 and 3.
setup.exe program. Please refer to the documents on the CD for further
instructions on installing the software. The setup executable, once
launched, will:
a. Ask for confirmation of the End-User License Agreement.
b. Present a small README, which explains that after installation,
the Crypto Officer can add a new port to their printer driver that
will support Lexmark PrintCryption
Note: Please refer to Crypto Officer Guidance section for more
information.
c. Perform the installation, and stop and restart the print spooler.
printed in step 1.
serial number label. Lexmark provides the Option Added label with the
Installation guide.
Page 13 of 17
TM
.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 10G0149 - PrintCryption Card Encryption Module and is the answer not in the manual?

This manual is also suitable for:

Printcryption

Table of Contents