Lexmark 10N0016 Refill Instructions

Refill Instructions -
Lexmark 10N0016 (No.16)
Lexmark All in One X72 . X74 . X75 . X1 130 . X1150 . X1180
. X225
Color Jetprinter Z13 . Z23 . Z25 . Z33 . Z34 . Z35 . Z515 .
Z601 . Z605 . Z615

Items Required

Original Lexmark 16 Cartridge, Syringe & Filling
Black Ink 10ml

Instructions

1. Assemble syringe and steel filling tube and fill with
appropriate colour ink. (g.2)
2. Remove the top from the black ink bottle and using
the syringe remove 10ml of black ink (g.3)
3. The filler hole is located on top of the cartridge.
(g.4)
4. Insert the steel filling tube into the appropriate filling
holes. (g.5). Push down into centre of the sponge.
IMPORTANT: Cartridge contains a sponge and a
slight resistant may be felt.
5. SLOWLY Inject ink. When ink overflows from filling
hole or starts to leak from print heads cartridge is full.
Stop injecting immediately
Blot printer heads with tissue before continuing to fill
next colour .
IMPORTANT: Clean syringe with water and dry
before refilling next colour
6. After refilling replace label back over filling hole.
7. Leave the cartridge to stand overnight on non-
absorbent surface this will ensure no
leakage and give the ink time to fully saturate the
sponge.
IMPORTANT: DO NOT LEAVE ON TISSUE.
8. Install cartridge and run a priming cycle.
PLEASE NOTE: The ink indicator level may need to
be turned of f. Check your HP instructions manual for
details.
fig.1
.
.
Order your
Refill PACKs at:
fig.2
www.
Tube
Black
Refilling
Hole
4
refill
.com
fig.3
fig.4
fig.5