Epson EMP-715 User Manual page 27

7
To change the projection time for a scenario page or to add display effects, right-click
the desired cell and select [Cell Properties].
To apply the same setting to multiple cells, select each cell while holding down the
[Shift] or [Ctrl] key on the keyboard, and then right-click and select [Cell Properties].
8
The "Cell Settings" dialog box is displayed. Specify the desired settings while referring
to the table below, and then click the [OK] button.
Advance
Displays Cell
Effect
The projection time can be set between 1 and 1800
seconds. In manual mode, the page can be switched by
pressing the [Enter] button on the remote control when
projecting.
When this is checked, the corresponding cells are
displayed. When unchecked, cells are hidden and a
prohibitive symbol is attached to them. (The same setting
can also be performed by selecting [Show (Hide)] in the
menu that appears after right-clicking the cell.)
Effects can be applied when switching screens during
projection in the same way that they are performed with
PowerPoint's slide-transition effect. The following are
some examples of effects. Display effects can be specified
for multiple cells at the same time. To select multiple cells,
click each cell while holding down the [Shift] or [Ctrl] key
on the keyboard.
Slide In/Out: Switches screens from left or right.
Box Wipe In/Out: Switches screens from outside or inside.
Creating Scenarios (EMP SlideMaker) -
25