Advertisement
13. Do not place the heated straight-
ener directly on any surface or on
the appliance power cord while it is
hot or plugged in.
14. Before plugging in read the infor-
mation about dual voltage contained
in the instruction section of this
manual.
15. Do not attempt to touch the housing
of your appliance near the straighten-
ing plates as it is hot when in use.
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
This straightening iron appliance is intended
for household use. This unit is designed to
operate at 125/250 volts AC. Use on Alternat-
ing Current (50/60 hertz) only.
This appliance has a polarized plug (one blade
is wider than the other). As a safety feature,
this plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact
a qualified electrician. Do not attempt to de-
feat this safety feature.
DUAL VOLTAGE
This straightening iron will automatically
adjust to the proper voltage. Use an adapter
plug with correct configuration, prior to use
in outlet.
STRAIGHTENING BASICS
1. Plug the straightening iron cord into any
household outlet (125/250V). Press ON but-
ton. Red and green lights will blink alternate-
ly. When ready to use, green light will remain
on and red light will turn off. The iron will
heat up very quickly. To turn off, press OFF
button. Green light will go off. Red light will
remain on as a safety precaution to indicate
the iron is still plugged in. Never leave your
straightening iron on and unattended.
WARNING:
The
ceramic-coated plates will get very hot
within a few seconds and should not be
placed in contact with the skin after the
straightening iron has been turned on.
Start with a hair section that is 1" wide and
no more than 1/8" thick. Open the iron and
place a hair section between the two hot
plates, close to the scalp. Trap hair between
the plates by firmly squeezing the handles
together. While maintaining the tension,
slowly pull the unit down along the hair sec-
tion toward the end of hair. At the end of hair
section, release the pressure on the handle
and allow the hair section to slide out. Re-
peat process on additional sections of hair
until you achieve the hair style you desire. It
may be necessary to repeat process on cer-
tain areas, depending on the texture of your
hair or how damp it is.
straightening
iron's
Advertisement
