Citizen CT-S2000DC User Manual page 28

2. Selecting memory switch
When the FEED button is pressed short (within 2 seconds), printing occurs in the
order of "Memory SW1" → "Memory SW2" → "Memory SW3" → ......"Memory
SW10" → "Save To Memory" → "Memory SW1" → ...... repeatedly. When the
memory switch you want to change is reached, press and hold the FEED button (for
more than 2 seconds).
3. Selecting each switch item
3-8 items are provided for setting in each switch. By pressing and holding the
FEED button long, the printer goes to the next item and prints the current setting of
the item. Repeat pressing and holding till the item you want to change is reached.
Power ON notify setting (Valid
4. Changing the setting
When the item you want to change is printed, press the FEED button short. The
changed set value is printed. (When change of set value is repeated, the original
set value is recovered). When you press the FEED button long, the set value is
accepted and then the printer goes to the next setting item.
5. Returning to the memory switch select mode
When the setting of the desired content is completed, open the printer cover and
then close the printer cover. This allows the printer to print the setting of the changed
memory switch.
6. Saving the setting and exiting the memory switch setting mode
Press the FEED button short to move to "Save To Memory". Then press and hold
the FEED button. The printer prints the content of new setting and exits the memory
switch setting mode to return to the normal standby state.
* Unless saving the setting is executed, the changed setting cannot be
enabled.
7. Initializing the memory switch
When you want to return the memory switch setting to the initial state, go to "Save
To Memory" in the above procedure. Here, open the printer cover and press and
hold the FEED button till buzzer sounds. This allows the printer to return to the
initial state.
* All the memory switches settings are returned to the factory set values.
(With memory switch 7-10, ERROR LED goes on only at the factory setting.)
)
— 25 —
OFF state: ERROR LED OFF
ON state: ERROR LED ON