Foxconn H61AP Series User Manual page 23

HARDWARE INSTALLATION
Header
front Panel
This motherboard includes one connector for
connecting the front panel switch and LED
Indicators.
Hard Disk LeD Connector (HDD-LeD)
Connect to the chassis front panel IDE
indicator LED. It indicates the active status
of the hard disks. This 2-pin connector is
directional with +/- sign.
Reset Switch (ReSeT-SW)
Attach the connector to the Reset switch on
the front panel of the case; the system will
restart when the switch is pressed.
Power LeD Connector (PWR-LeD)
Connect to the power LED indicator on the
front panel of the chassis. The Power LED
indicates the system's status. When the
system is in operation (S0 status), the LED
is on. When the system gets into sleep mode
(S1) , the LED is blinking; When the system
is in S3/S4 sleep state or power off mode
(S5), the LED is off. This 2-pin connector is
directional with +/- sign.
Power Switch Connector (PWR-SW)
Connect to the power button on the front
panel of the chassis. Push this switch allows
the system to be turned on and off rather than
using the power supply button.
TPM Header : TPM
The TPM (Trusted Platform Module) provides the
ability to the PC to run applications more secure
and to make transactions and communication
more trustworthy. To utilize this function, you
should purchase additional device and install it.
fan Headers : CPU_fAN, SYS_fAN1
The fan speed can be controlled and monitored
in the BIOS Setup. These fans can be automati-
cally turned off after the system enters S3, S4
and S5 sleeping states
16
: fP1
1
+
HDD-LED
-
RESET-SW
NC
9
1 2
LCLK
GND
LFRAMEn
EMPTY
LRESETn
NC_3
LAD3 LAD2
VDD LAD1
LAD0 GND
NC_1 NC_4
NC_2 SERIRQ
GND CLKRUNin
LPCPDn NC_5
19 20
TPM
GND
1
POWER
SENSE
CONTROL
CPU_FAN/SYS_FAN1
2
+
PWR-LED
-
PWR-SW
EMPTY
10
FP1