Foxconn H61M-S User Manual page 24

This motherboard includes one connector for connecting
the front panel switch and LED Indicators.
Hard Disk leD Connector (HDD-leD)
Connect to the chassis front panel IDE indicator LED. It
indicates the active status of the hard disks. This 2-pin
connector is directional with +/- sign.
Reset Switch (ReSeT-SW)
Attach the connector to the Reset switch on the front
panel of the case; the system will restart when the
switch is pressed.
Power leD Connector (PWR-leD)
Connect to the power LED indicator on the front panel
of the chassis. The Power LED indicates the system's
status. When the system is in operation (S0 status),
the LED is on. When the system gets into sleep mode
(S1) , the LED is blinking; When the system is in S3/S4
sleep state or power off mode (S5), the LED is off. This
2-pin connector is directional with +/- sign.
Power Switch Connector (PWR-SW)
Connect to the power button on the front panel of the
chassis. Push this switch allows the system to be turned
on and off rather than using the power supply button.
TPM Connector : TPM
The TPM (Trusted Platform Module) provides the ability
to the PC to run applications more secure and to make
transactions and communication more trustworthy. To
utilize this function, you should purchase additional device
and install it.
fan Connectors : CPU_fAN, SYS_fAN1
There are two main fan headers on this motherboard.
The fan speed can be controlled and monitored in "
Health" section of the BIOS Setup. These fans can be
automatically turned off after the system enters
S3, S4 and S5 sleeping states.
RESET-SW
17
17
1 2
+ +
HDD-LED PWR-LED
-
-
PWR-SW
EMPTY
NC
9 10
FP1
1 2
LCLK GND
LFRAMEn EMPTY
LRESETn NC_3
LAD3 LAD2
VDD LAD1
LAD0 GND
NC_1 NC_4
NC_2 SERIRQ
GND CLKRUNin
LPCPDn NC_5
19 20
TPM
GND
1
POWER
SENSE
CONTROL
CPU_FAN/SYS_FAN1