Foxconn D70S-P User Manual page 18

front Panel Header : fP1
This motherboard includes one header for
connecting the front panel switch and LED
Indicators.
Hard Disk LeD Connector (HDD-LeD)
Connect to the chassis front panel IDE
indicator LED. It indicates the active status
of the hard disks. This 2-pin connector is
directional with +/- sign.
Reset Switch (ReSeT-SW)
Attach the connector to the Reset switch on
the front panel of the case; the system will
restart when the switch is pressed.
Power LeD Connector (PWR-LeD)
Connect to the power LED indicator on the
front panel of the chassis. The Power LED
indicates the system's status. When the
system is in operation (S0 status), the LED
is on. When the system gets into sleep mode
(S1) , the LED is blinking; When the system
is in S3/S4 sleep state or power off mode
(S5), the LED is off. This 2-pin connector is
directional with +/- sign.
Power Switch Connector (PWR-SW)
Connect to the power button on the front
panel of the chassis. Push this switch allows
the system to be turned on and off rather than
using the power supply button.
Serial ATA Connectors : SATA_1/2/3/4
The Serial ATA connector is used to connect with
SATA Hard Disk or CD devices which support
this feature. The SATA_2/3/4 allows up to 3GB/s
data transfer rate, the SATA_1 support SATA
3.0 specification, and allows up to 6GB/s data
transfer rate.
TPM Header : TPM
The TPM (Trusted Platform Module) provides the
ability to the PC to run applications more secure
and to make transactions and communication
more trustworthy. To utilize this function, you
should purchase additional device and install it.
HARDWARE INSTALLATION
1
+
HDD-LED
-
RESET-SW
NC
9
1
GND
TX+
TX-
GND
RX-
RX+
GND
SATA_1
SATA_2/3/4
1 2
LCLK
GND
LFRAMEn EMPTY
LRESETn 5V_SYS
LAD3 LAD2
VDD
LAD1
LAD0
GND
NC_1 NC_4
3D3V_DUAL SERIRQ
GND CLKRUNin
LPCPDn NC_5
19 20
TPM
2
+
PWR-LED
-
PWR-SW
EMPTY
10
FP1
1
GND
TX+
TX-
GND
RX-
RX+
GND
11