Fox Intelligent Stepping - Foxconn A76ML-K 3.0 User Manual

Fox Intelligent Stepping

CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
CPU Clock Adjust
CPU Multiplier Adjust
Current CPU Speed
CPU-NB HT Link Speed
Current FSB/HTT Speed
CPU-NB Multiplier Control
Current CPU-NB Speed
Memory Speed Mode
Current DRAM Speed
GFX Engine Clock Override
PCIE Clock Abjust
Spread Spectrum
► CPU Clock Adjust
This option is used to adjust the CPU clock.
► CPU Multiplier Adjust
This option is used to adjust the CPU Clock Ratio. Multiply CPU clock with this ratio, you can
get the CPU speed. Increase this ratio may overclock your CPU. This option will be valid if
your CPU ratio is unlocked and will be displayed only if your CPU is supporting this feature.
► CPU-NB HT Link Speed
HT stands for HyperTransport bus. The CPU<->NB HT Speed option controls the physical
speed of the CPU to Northbridge HT link. The physical speed of the link is determined by
multiplying the CPU clock with the CPU<->NB HT Speed setting.
► CPU-NB Multiplier Control
This item is used to select CPU-NB Multiplier run as Auto or Manual mode.
Select [Auto] for CPU-NB default speed.
Select [Manual], then CPU-NB speed is manually selected according to the setting of "CPU-
NB Multiplier Adjust".
► CPU-NB Multiplier Adjust
This item is used to set CPU-NB Multiplier.It is displayed only when "CPU-NB Multiplier Con
trol" is set as manual mode.
► Current CPU-NB Speed
This item displays the current CPU-NB Speed.
► Memory Speed Mode
This item is used to enable/disable provision of DRAM timing by SPD device. The Serial
Presence Detect (SPD) device is a small EEPROM chip, mounted on a memory
module. It contains important information about the module's speed, size, addressing mode
and various other parameters, so that the motherboard memory controller (chipset) can better
access the memory device.
Select [Auto] for SPD enable mode.
Select [Limit], the DRAM speed will not exceed the specified value listed in the "Memory
Fox Intelligent Stepping
[200]
200
[Auto]
: 3000MHz
[Auto]
: 2000MHz
[Auto]
: 2000MHz
[Auto]
: N/A , 1067MHz
[Disabled]
[100]
[Enabled]
↑↓←→:Move Enter:Select
F1:General Help
Help Item
+/-/:Value F10:Save ESC:Exit
F9:Optimized Defaults
29