Important!
CT-SSP rack-mount
installation
CT-SSP stand-alone
installation instructions
10
• Allow at least three inches (7.5 cm) of clearance above and to each
side of the processor for ventilation. Do not obstruct the area around
the processor so that excess heat can dissipate through normal air
circulation. Avoid placing the processor on a soft surface, such as
plush carpeting, that may restrict airflow.
Obey all placement considerations. Not obeying the
placement considerations may result in damage that is not
covered under the warranty.
FOR RACK MOUNTING INSTALLATION CONTACT YOUR CLASSÉ
PROFESSIONAL.
NON-RACK-MOUNT INSTALLATION FOR SSP:
1a. Install (4) feet and secure with (4) #6 flat washers and
(4) 6-32 X 9/16 philips pan head screws.
Optional accessory feet can be purchased and installed as below.
Tighten to
5.0 in-lbs (0.56 N-m)