Section 4: General Configuration; Base Radio Displayed Messages; 1: The Read Only Sequence; The Read Only Sequence - Honeywell XYR 5000 Series User Manual

Honeywell Industrial Wireless

Section 4: General Configuration

4.1: Base Radio Displayed
Messages
NOTE
During configuration and testing, keep Transmit-
ters at least one foot apart and away from the Base
Radio to ensure good communications.

4.1.1: The Read Only Sequence

10 Rev. 3
11/04
This section discusses the generalities around configuring the Base Radio
via the next and enter buttons. The subsections are as follows:

4.1: Base Radio Displayed Messages

4.1.1: The Read-Only Sequence
4.2: The Overall Configuration Menu Map
4.3: The Number of Wireless Instruments Setting
4.4: Setting a User Password
The Base Radio should be on if power is being supplied (See Section 3.2:
Electrical Installation). Upon power-up, the Base Radio will display a
Power-Up Sequence, and then go into an Operations Sequence. These
Sequences are shown in Figure 4.1 below:
Figure 4.1: Base Radio Power-Up and Operations LCD Sequences
Once the Base Radio is in the Operations Sequence, a user may access the
READ-ONLY Sequence without a password by simply pressing the EN-
TER button at any time. The Read-Only Sequence, as shown in Figure 4.2,
displays extra information about the current settings of the Base Radio that
are not seen during the Operations Sequence, but does not allow any
changes to be made to these settings.

4.2: The Read Only Sequence

User Manual
Wireless Base Radio