General Configuration; Base Radio Displayed Messages; The Read Only Sequence; Figure 4-1 Base Radio Power-Up And Operations Lcd Sequences - Honeywell ISM BAND XYR 5000 LINE User Manual

4

General Configuration

This section discusses the generalities around configuring the Base Radio via the NEXT
and ENTER buttons. The subsections are as follows:

4.1: Base Radio Displayed Messages

4.1.1: The Read Only Sequence

4.2: Overall Configuration Menu Map
4.3: Setting the User Password
4.1 Base Radio Displayed Messages
The Base Radio should be on if power is being supplied (See Section 3.2: Electrical
Installation). Upon power-up, the Base Radio will display a Power-Up Sequence, and
then go into an Operations Sequence. These Sequences are shown in Figure 4-1 below:
Note During configuration and testing, keep Transmitters at least six feet from the Base
Radio and other Transmitters to ensure good communications.
4.1.1 The Read Only Sequence
Once the Base Radio is in the Operations Sequence, a user may access the READ-
ONLY Sequence without a password by simply pressing the ENTER button at any time.
The Read-Only Sequence, as shown in Figure 4.2, displays extra information about the
current settings of the Base Radio that is not seen during the Operations Sequence. No
changes may be made to these settings here.

Figure 4-1 Base Radio Power-Up and Operations LCD Sequences

16