Troubleshooting; Specifications - Strong SRT 5492 User Manual

Troubleshooting

There may be various reasons for the abnormal operation of the unit. Therefore, if the unit
does not work properly, check it according to the procedures shown in the table below:
Problem Possible causes
Wrong connection of the
No Picture or sound.
video/audio output to the
TV input terminal.
Wrong connection of the
terrestrial cable.
No signal or weak signal.
Wrong setting of channel
information in the MENU
screen.
Your TV mode (PAL/NTSC)
Black-and-white
screen or V-Hold. is different from the
terrestrial broadcasting
mode.
The remote controller is Batteries are exhausted.
not working.
Fluorescent light is
interfering with the remote
controller.
Remote controller is
incorrectly aimed.
Remedy
Connect the two terminals
correctly with RCA or RF cable(s),
HDMI cable(s).
Connect the antenna cable
correctly.
Adjust the direction of the
antenna.
Check the cable connections
Type the setting values correctly.
Use a TV of the same mode.
Connect a NTSC/PAL converter
between the receiver and the TV.
Change the batteries.
Switch off the light.
Aim the remote control at the
receiver.
48

Specifications

Fully DVB compliant
System capabilities
TERRESTRIAL Input connector
Loop-through out
System capabilities
Frequency range
Tuner
Input impedance
& Channel Decoder
Signal level
IF Bandwidth
Waveform
Carrier Mode
Code Rate
Guard Interval
Processor
System resource
DDR SDRAM
FLASH
EEPROM
Video decoder MPEG 2
Data Rate
Resolution
Video format
Aspec Ratio
Teletext DVB compliant
MPEG 1 layer I/II,
MPEG Audio
MPEG 2 layer II,
AC3 Dolby Digital
Type
Sampling rates
Connector
Serial data interface
Code
Remote control
Operating condition
USB USB Supply
Antenna Supply
Terrestrial ant input
IEC 169-2, Female
IEC 169-2, Male
170 ~ 230 MHz, 470 ~ 862MHz
75 Ohms Nominal
7,8MHz(-78dBm~-25dBm) switchable by software
7,8MHz(-3dB) switchable by software
OFDM
2k and 8k hierarchical/non-hierarchical
1/2, 2/3, 3/4, 5/6, 7/8
1/4, 1/8, 1/16, 1/32
32bit processor (266MHz)
64Mbyte X 2, 32Mbyte X 2
8Mbyte
256Kbit
MPEG-2, MPEG-4, H.264
up to 15M bits/s
1920 X 1080i, 1280 X 720P, 720 X 576P/i
PAL
4:3,16:9
Mono, Stereo, Joint Stereo
32, 44.1 and 48 KHz
9pin D-sub male, Max 115K bps
NEC-IR
up to 7 Meter
DC 5V Max 500mA
DC 5V Max 100mA
49