Operation; Getting Started - Strong SRT 5492 User Manual

Operation

6.1 Getting Started

After your receiver is powered on, proceed with installation as follows :
1) Installation Wizard
Turn on your TV and receiver.
The pop-up menu for language selection will appear.<Figure 6.1.1>
Select one language and press to proceed.
A/V Output Settings menu appear after Menu Language menu. <Figure 6.1.2>
See also Page19
<Figure 6.1.1>
Time Settings menu appear after A/V Output Settings menu. <Figure 6.1.3>
See also Page18
Auto Scan menu appear after Time Setting menu. <Figure 6.1.4> See also Page13
Note : This menu also appear after factory Set.
<Figure 6.1.3>
<Figure 6.1.2>
<Figure 6.1.4>
12
6.1 Getting Started
2) Terrestrial Scan
Through this function, the receiver searches for all the available channels and saves
them in memory.
Auto Scan <Figure 6.1.5>
Press the OK button when the selection bar is positioned on any item and
"Scanning menu" will appear on the screen. <Figure 6.1.6>
<Figure 6.1.5>
Manual Scan <Figure 6.1.7>
Select the channel number or frequency you want to search for select the channel
number by pressing VOL or VOL
by entering the frequency with the number keys. <Figure 6.1.8>
For the Bandwidth choose either 7 MHz or 8 MHz.
Select the Search Type (All channel / FTA Only / TV Only).
Select the Network Search ON / OFF.
Press to begin the scan.
<Figure 6.1.7>
<Figure 6.1.6>
on the remote control, or specify a frequency
<Figure 6.1.8>
13