Casio TE-2200 User Manual page 17

Tax table programming (continued...)
Programming U.S.tax tables
Before you can program a U.S. tax table, you must first calculate the program data.
The partial tax table shown below is for a tax rate of 6%. A tax amount is applied for each price
range, which is defined by a low end minimum break point. If you subtract each maximum break
point from the next lower maximum break point, you should soon be able to see certain patterns. In
a cyclic pattern, the differences in maximum breakpoints form a regularly repeating cycle. A pattern
which does not fit the cyclic pattern is called non-cyclic pattern.
Though rate, it is conceivable that you can find that subtracting maximum breakpoints results in an
one big non-cyclic pattern. In this case, you won't be able to use automatic tax calculation, and
must enter the tax for each transaction manually or use a tax rate.
Example 1, Add-on rate tax:
Programming procedure:
Tax rate (2-digit for integer + 4- digit for decimal)
Tax table maximum value ("0" means unlimited).
Rounding/tax table system code
Sum of a cyclic pattern
Number of values in each cyclic pattern
Number of values in each non-cyclic pattern
Actual value of difference of the non-cyclic and cyclic values
X1
REG2
Z1
REG1
X2/Z2
OFF
RF
PGM
Mode Switch
TE-2200 User's Manual
3s
8
{
: : : : s
8
8^25a
8
0a
8
5002a
8
s
8.25%
0 (no limitation)
5002 (Round off)
0
}
0
No need to enter.
0
0
Tax table 1 = 0125
Tax table 2 = 0225
Tax table 3 = 0325
Tax rate (2-digit for integer + 4-digit for decimal)
Tax table maximum value ("0" means unlimited).
Rounding/tax table system code
17
E
www.cashregisters.net