D-Link DSL-2750U User Manual page 36

DSL-2750U User Manual
The IP address available in the DHCP IP address pool changes automatically if you
change the IP address of the device.
You can also enable the secondary LAN IP address. The two LAN IP addresses
must be in different networks.
Choose Setup > Local Network. The Local Network page shown in the following
figure appears.
By default, Enable DHCP Server is selected for the Ethernet LAN interface of the
device. DHCP service supplies IP settings to workstations configured to
automatically obtain IP settings that are connected to the device through the
Ethernet port. When the device is used for DHCP, it becomes the default gateway
for DHCP clients connected to it. If you change the IP address of the device, you
must also change the range of IP addresses in the pool used for DHCP on the LAN.
The IP address pool can contain up to 253 IP addresses.
33