Honeywell ERX User Manual page 34

10. Click Ok to the following Modal screen to continue
11.A number of status screens will appear:
Connecting to MPA
Erasing Current Firmware
Sending New Firmware
Verifying Firmware Upgrade
12. Finally, if the upgrade procedure was successful, the following screen will display the newly
installed firmware version
13. Click Close
14. Discount link and re-link to recorder using MasterLink32 software and upload the item file
created previously, then load Non-Cal Items and Cal Items to restore the configuration and
calibration items.
15. Reset the date and time in recorder.
16. Verify the ERX Recorder has the proper configuration.
www.honeywell.com
34
