NETGEAR R6200 User Manual page 10

Table 1. Front panel LED descriptions
LED Description
• Solid amber. The router is starting up.
Power
• Blinking amber. The firmware is upgrading, or the Restore Factory Settings button was
pressed.
• Solid green. The router is ready.
• Blinking green. The firmware is corrupted. See www.netgear.com/support.
• Off. Power is not supplied to the router.
• Solid green. The Internet connection is ready.
Internet
• Solid amber. The Ethernet cable connection to the modem has been detected.
• Off. No Ethernet cable is connected to the modem.
• Solid blue. The wireless radio is operating in either 2.4 GHz or 5 GHz mode.
Wireless
• Blinking: The router is in WPS mode.
• Off. The wireless radios are off for both 2.4 GHz and 5 GHz.
• Solid blue: The router has accepted the USB device. The USB device is ready to be used.
USB
• Blinking blue: A USB HDD is plugged in and is trying to connect.
• Off: No USB device is connected, someone clicked the Safely Remove Hardware button and
it is now safe to remove the attached USB device.
The WiFi and WPS buttons toggle the WiFi and WPS functions on and off.
• WiFi On/Off button. Pressing and holding the wireless LAN button for 2 seconds turns
the 2.4 GHz and 5 GHz wireless radios on and off. If the 2.4 GHz and 5 GHz LEDs are lit,
then the wireless radio is on. If these LEDs are off, then the wireless radios are turned off
and you cannot connect wirelessly to the router.
• WPS button. You can use this button to use WPS to add a wireless device or computer
to your wireless network. The Wireless LED blinks blue when the router is trying to add
the wireless device or computer. The LED stays solid blue when wireless security is
enabled in the router.
Dual Band 11ac WiFi Router R6200
Hardware Setup
10