Settings For Best Results - Electrolux 30” Electric/Microwave Combination Wall Oven Use & Care Manual

20 Setting for Best Results
Removing and replacing
extendable oven racks
Always arrange the oven racks when the oven is
cool (prior to operating the oven).
Always use oven mitts when using the oven.
To remove an oven rack, pull the rack forward.
Lift up the rack off the oven rack slider. To install
an oven rack, locate the two pinholes in the small
plates at the front corners of the rack. Place the
rack on the side sliders and drop the pin holes over
the pins on the sliders.
Pull oven rack forward and lift
it up off the oven rack slider.
Do not try to install the extendable oven racks into
the standard oven rack levels (or rack support).
Installing standard oven
racks
Always arrange the oven racks when the oven is
cool (prior to operating the oven).
Always use oven mitts when using the oven.
To install, take a standard oven rack with the handle
in front of you and the stoppers looking down. Align
the rear of the rack on the level you want to install
it, then push on the rack to slide it in the level until it
stops.
Installed on
sliders
To remove
from sliders
This stopper will prevent the rack to bump on the
convection fan cover at the end of its course.
To place on
sliders
This "safety stopper" will stop the rack when you
pull it out. This will prevent you to accidentally pull
the rack too far and make it fall.
Do not try to install the standard oven rack on the
sliders.
Must point
upward