Husqvarna AUTOMOWER 265 ACX Operation Manual page 55

Different corridor widths can be set for the
boundary wire, guide 1 and on guide 2. The
default setting on Automower
19 for both the boundary wire and guide wires.
The higher the stated Corridor width value, the
less risk there is of tracks forming. However, a
high corridor value means that Automower
find it difficult to enter passages.
A garden with large open areas should have a
wide Corridor, i.e. a high Corridor width value.
A garden with passages should have a narrow
Corridor, i.e. a low value for the Corridor width.
When the value is set to 0 for the Corridor width,
Automower will run along the boundary wire,
®
which means it will run with half the mower inside
the loop and half the mower outside. As there
are often flower beds, hedges and walls along
with the boundary wire Corridor width 0 is not
normally recommended. Should you still like to
state this value, the boundary wire must lay 20"
(50 cm) from solid objects instead of the normal
16" (40 cm).
IMPORTANT INFORMATION
The distance at which the mower follows the
boundary wire varies depending on how the
working area appears. You should perform
some tests to find the highest possible
Corridor width. Use the Test IN (3-2-4)
function to try different values.
• Test IN (3-2-4)
The Test IN (3-2-4) function is used to test how
Automower ® finds its way into the charging
station.
6. MENU FUNCTIONS
is set to a value of
®
® may
Follow loop out
Follow loop in
Corridor width
Test IN
Test OUT
3-2-3
20"
Follow loop out
Follow loop in
Corridor width
Test IN
Test OUT
3-2-4
Boundary corridor
Guide 1 corridor
Guide 2 corridor
English - 55