Husqvarna AUTOMOWER 265 ACX Operator's Manual page 2

G E T TI NG STARTE D
W ITH H U SQVARNA AUTOM OW E R
1
PL AC E M E NT AN D CON N ECTI NG TH E C HARG I NG STATION
See chapter 3.2 in the Operator's Manual
1. Place the charging station centrally in the work area,
leaving a lot of free space in front of the charging station
and on a relatively horizontal surface.
2. Connect the low voltage cable to the charging station and
transformer.
3. Connect the transformer's power cord to an electrical wall
socket. The 120 V transformer (USA) is for indoor use only.
2
C HARG I NG TH E BAT TE RY AN D PLAC I NG TH E
BOU N DARY WI RE
See chapters 3.3 and 3.4 in the Operator's Manual.
1. Place Automower ® in the charging station to
charge the battery while you are laying the
boundary wire. Set the main switch to
the OFF position.
2. Run the boundary wire ensuring it
forms a loop around the work area.
35 cm / 14"
1. Charging strip
2. Latch button to open the cutting
height adjustment cover
3
3. STOP button
4. LED for performance inspection
2
of boundary wire
5. Contact strips
1
6. Keypad
7. Display
®
3
0 cm / 0"
5
4
6 7
Main menu
Commands
Timer
Garden
Settings
3
CON N ECTI NG TH E BOU N DARY WI RE
See chapter 3.5 in the Operator's Manual
1. Lift off the cover on the charging station and push in the
2
2. Open the connector and run the wire ends in the recesses
2
3. Press the connector together using a pair of pliers.
4. Cut off any surplus boundary wire.
5. Press the connector onto the contact pin,
4
STARTI NG AN D STOPPI NG AUTOMOWE R
10 cm / 4"
See chapters 3.7, 4.4 and 4.5 in the Operator's Manual.
STARTING
1. Open the control panel cover by pressing the STOP button.
2. Set the main switch to ON position. When you do this for
3. Close the cover.
STOPPING
Press the STOP button.
40 cm / 15"
Charging station Transformer
ends of the boundary wire in the lower holes of the
charging station and catch them in the upper holes:
• Right wire end in right hole.
• Left cable end in left hole.
on each connector.
Cut 1-2 cm / 0.5-0.78" above the connector.
marked A, on the charging station.
Refit the cover on the charging station.
the first time, a start up sequence starts where you select a
four digit PIN code among other things. The mower must
be in the charging station when you select a PIN code.
Low voltage cable Boundary wire *
and connector
1
2 3
4 5
®
2 3
Pegs * Connector Measurement gauge
* Not included in package