Wall Mounting The Speakers - Pioneer XV-BD505FS Operating Instructions Manual

18 Installation

Wall mounting the speakers

Before mounting
Remember that the speaker system is heavy
and that its weight could cause the screws
to work loose, or the wall material to fail to
support it, resulting in the speaker falling. Make
sure that the wall you intend to mount the
speakers on is strong enough to support them.
Do not mount on plywood or soft surface
walls.
Mounting screws are not supplied. Use screws
suitable for the wall material and support the
3
weight of the speaker.
CAUTION
• If you are unsure of the qualities and strength of
the wall, consult a professional for advice.
• Pioneer is not responsible for any accidents or
damage that result from improper installation.
Mounting
Screw
(Not supplied)
5 mm to 7 mm
Attaching the speakers
The front speaker can be hung vertically or
horizontally on the wall.
Use one hole to hang it vertically and two
holes to hang it horizontally. The illustration
below shows the front right speaker.
Vertical set up
Hole
Horizontal set up
When installing the speaker horizontally, set
it up so that the speaker terminal on the back
side of the speaker is on the outside on the
end of the surface, farthest away from the
other speaker.
Speaker terminal
Front right
NOTE
Do not connect the supplied speakers to any
amplifi er other than the one supplied with this
system. Connection to any other amplifi er may
result in malfunction or fi re.
Holes
Speaker terminal
Front left