Wall Mounting The Speakers - Pioneer BCS-FS500 Operating Instructions Manual

] Connect the wires to the player.
Connect the white wire with gray line into (+) side and the other wire into (–)
side. To connect the cable to the player, press each plastic finger pad to
open the connection terminal. Insert the wire and release the finger pad.
Orange (+)

Wall mounting the speakers

The front speaker have mounting holes.
Before mounting
• Remember that the speaker system is heavy and that its weight could cause
the screws to work loose, or the wall material to fail to support it, resulting in
the speaker falling. Make sure that the wall you intend to mount the speakers
on is strong enough to support them. Do not mount on plywood or soft sur-
face walls.
• Mounting screws are not supplied. Use screws suitable for the wall material
and support the weight of the speaker.
Cautions:
• If you are unsure of the qualities and strength of the wall, consult a profes-
sional for advice.
• Pioneer is not responsible for any accidents or damage that result from
improper installation.
Mounting screw
(not supplied)
5 mm to 7 mm
14
Red (+)
White (+)
Black (–)
5 mm
10 mm
Attaching the speakers
The front speaker can be hung vertically or horizontally on the wall. Use one
hole to hang it vertically and two holes to hang it horizontally. The illustration
below shows the front right speaker.
Vertical set up
Horizontal set up
When installing the speaker horizontally, set it up so that the speaker terminal
on the back side of the speaker is on the outside on the end of the surface, far-
thest away from the other speaker.
Speaker terminal
Front right
Note:
Do not connect the supplied speakers to any amplifier other than the one
supplied with this system. Connection to any other amplifier may result in
malfunction or fire.
Hole
Holes
Speaker terminal
Front left