English - Navman THROUGH HULL AND IN-HULL Installation Manual

FCC Statement
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a normal installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an output on a circuit different from that to which the
receiver is connected
Consult the dealer or an experienced technician for help
A shielded cable must be used when connecting a peripheral to the serial ports.
Important
It is the owner's sole responsibility to install and use Navman's transducers in a manner that
will not cause accidents, personal injury or property damage. The user of this product is solely
responsible for observing safe boating practices.
Transducer installation: The choice, location, angle and installation of the transducer is the most
critical part of installation. If installation is not correct, the unit can not perform at its designed
potential. If in doubt, consult your Navman dealer. Ensure that any holes that cut are in a safe
position and will not weaken the boat's structure. If in doubt, consult a qualifi ed boat builder.
Disclaimer: The information in this manual is provided as a guide only. The transducer's
performance is infl uenced by the boat's material, hull design and engine installation and these
are beyond the control of Navman NZ Limited.
NAVMAN NZ LIMITED DISCLAIMS ALL LIABILITY FOR ANY USE OF THIS PRODUCT IN A
WAY THAT MAY CAUSE ACCIDENTS, DAMAGE OR THAT MAY VIOLATE THE LAW.
Governing language: This statement, any instruction manuals, user guides and other information
relating to the product (Documentation) may be translated to, or has been translated from,
another language (Translation). In the event of any confl ict between any Translation of the
Documentation, the English language version of the Documentation will be the offi cial version
of the Documentation.
This manual represents the transducer installation procedures as at the time of printing. Navman
NZ Limited reserves the right to make changes to specifi cations without notice.
Copyright © 2003 Navman NZ Limited, New Zealand, all rights reserved. Navman is a registered
trademark of Navman NZ Limited.
2
NAVMAN
Through hull & In-hull transducer installation manual