Setting The Clock (Remote Control Only); Timer And Sleep Operation (Remote Control Only); Timer Playback - Sharp XL-UH12H Operation Manual

Setting the clock (Remote control
only)
In this example, the clock is set for the 24-hour (00:00)
display.
1
Press the ON/STAND-BY button to turn to stand-by
mode.
2
Press and hold the (TIMER)/CLOCK button until
"00:00" appear.
3
Within 10 seconds, press the
adjust the hour and then press the MEMORY button.
Press the or
by 1 hour. Hold it down to advance continuously.
4
Press the or
then press the MEMORY button. Press the
button once to advance the time by 1 minute. Hold it
down to advance continuously.
To confirm the time display:
[When the unit is in the stand-by mode]
Press the (TIMER)/CLOCK button. The time display will
appear for about 5 seconds.
[When the power is on]
Press the (TIMER)/CLOCK button. The time display will
appear for about 5 seconds.
Note:
The "00:00" will appear when the AC power supply is
restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from step 1.
or button to
button once to advance the time
button to adjust the minutes and
Timer and sleep operation (Remote
control only)

Timer playback:

The unit turns on and plays the desired source (CD, USB,
TUNER or AUDIO IN) at a preset time.
■ Timer playback
Before setting timer:
1
Check that the clock is set to the correct time (refer to
page 10).
If it is not set, you cannot use the timer function.
2
For timer playback, load the disc to be played back.
1
Press ON/STAND-BY button to turn the power on.
2
Press and hold (TIMER)/CLOCK button for about 2
seconds.
3
Within 10 seconds, press the
select "ONCE" or "DAILY" and then press the
MEMORY button.
4
Press the
MEMORY button.
5
Press the
press the MEMORY button.
or
6
Press the
the MEMORY button.
7
Press the
press the MEMORY button.
8
Press the
(CD, USB, TUNER, AUDIO IN) then press the
MEMORY button.
When you select TUNER, select a preset station by
pressing the
MEMORY button. If a station has not been
programmed, timer setting will be canceled.
E-11
or
or button to set hour then press the
or button to set minute and then
or button to set hour and then press
or button to set minute and then
or button to select wake up source
or button, and then press the
button to