Installing Your Gateway; Connect The Gateway To Your Computer; Figure 3 - Sbg6782-Ac Connection Diagram - Motorola ARRIS SURFboard eXtreme SBG6782-AC User Manual

Installing Your Gateway

3
This product is for indoor use only. Do not route the Ethernet cable
outside of the building. Exposure of the cables to lightning could create a
safety hazard and damage the product.

Connect the Gateway to Your Computer

Before installing the gateway:
•
Check with your service provider to ensure broadband cable access is available in your area.
To set up a wireless network, you will need a high-speed Internet connection provided by an
Internet service provider.
•
Choose a central location in your home where your computer and gateway are preferably
near existing cable and electrical wall outlets.
Note: The following steps you through the wired Ethernet connection process so that you can
quickly confirm that the gateway was properly connected and you can access the Internet.
1. Check that a coaxial cable is already connected to a cable wall outlet or RF splitter (optional).
2. Connect the other end of the coaxial cable to the Cable connector on the gateway.
Use your hand to tighten the connectors, to avoid damaging them.
SBG6782-AC Wireless Cable Modem & Router • User Guide
365-095-23865 x.1
Installing Your Gateway
Figure 3 – SBG6782-AC Connection Diagram
6