Chain Search - Radio Shack PRO-433 Quick Start Manual

Beyond the Basics

chain search

Chain search lets you search through preset frequency ranges and
store found frequencies. You can also modify each range.
At least one bank must be active. If you disable all the
NOTE
banks, the error tone beeps.
1
. Press SRCH. SRCH appears.
2
. (Optional) Press 0 – 9 to enable / disable search banks:
Bank No.
1 ...................................................29.0000 – 54.0000 ..............................5
2 ..................................................137.0000 – 147.9950 ..........................5
3 ...................................................179.7500 – 215.7500 ....................6000
4 ...................................................216.0000 – 224.9950 ..........................5
5 ...................................................225.0000 – 399.9875 .....................12.5
6 ...................................................400.0000 – 449.99375 ...................6.25
7 ...................................................450.0000 – 469.99375 ...................6.25
8 ...................................................470.0000 – 512.0000 .....................6.25
9 ...................................................806.0000 – 956.0000 .....................12.5
10 .................................................1240.0000 – 1300.0000 .................12.5
3
. Press or
4
. When the scan pauses, press HOLD/RESUME. To step through
the frequencies, press
5
. To save a frequency, press E/PGM. The bank numbers fl ash.
6
. Enter the target bank number. The smallest empty channel
number fl ashes over the frequency.
7
. Press or
8
. Press E/PGM.
To program a search range, complete the following steps:
1
. During a chain search, press and hold E/PGM. The lowest and
the highest frequencies of Bank 1 appear alternately.
2
. Press the number of the bank you want to change. The lower
frequency range appears.
Frequency (MHz)
to search up or down.
or .
to select to target channel.
17
Step (kHz)