Components
to provide more clearance when operating in
shallow water.
EMU30530
Tilt lock mechanism
The tilt lock mechanism is used to prevent
the outboard motor from lifting out of the wa-
ter when in reverse gear.
1
1. Tilt lock lever
To lock it, set the tilt lock lever in the lock po-
sition. To release, push the tilt lock lever in
the release position.
EMU26332
Tilt support bar
The tilt support bar keeps the outboard motor
in the tilted up position.
26
ECM01660
ZMU04111
NOTICE
Do not use the tilt support bar when
trailering the boat. The outboard motor
could shake loose from the tilt support
and fall. If the motor cannot be trailered in
the normal running position, use an addi-
tional support device to secure it in the
tilt position.
EMU26373
Cowling lock lever(s) (turn type)
To remove the engine top cowling, turn the
cowling lock lever(s) and lift off the cowling.
When installing the cowling, check to be sure
it fits properly in the rubber seal. Then lock
the cowling again by returning the cowling
ZMU03695
lock lever(s) to the lock position.
1. Cowling lock lever(s)
1
ZMU03699
ZMU03701