The Visioneer Mobility Scanner - Visioneer Mobility User Manual

8 V M
ISIONEER OBILITY
T V M
HE ISIONEER OBILITY
Alignment
arrow
Paper feed slot
Paper feed slot—Insert an item face up in the scanner, aligned to the arrow at the end of the paper feed
slot.
Control panel—Scanner controls.
• Power button—Press, hold-down for 3 seconds, then release the power button to turn the scanner on
or off. Note that the scanner will automatically power off after 2 minutes if not in use.
• Function button—Tap this button to cycle through the scan functions. Press, hold-down for 2
seconds, then release the button to initiate a calibration.
• Status LEDs—Indicates the scanner's current status. When it is reporting an error, all 3 LEDs will
blink simultaneously a few times, pause, then blink again. The number of times the LEDs flash
between pauses indicates the type of error.
LED pattern Scanner status
2 blinks Paper jam—the scanner has detected that a page is stuck. If possible, pull the page out
of the scanner from the back. Power cycle the scanner if needed.
3 blinks Scanner not linked—the scanner does not detect a storage device. Make sure a USB
flash drive or memory card is fully inserted into the back of the scanner. Power cycle
the scanner if needed.
4 blinks Calibration error—the scanner needs to be calibrated or the scanner failed to calibrate
successfully during a calibration routine. Re-start the calibration routine by press,
hold-down for 2 seconds, then release the function button.
5 blinks Timeout—the scanner timeout has started.
Continuous Scanner busy—either the scanner is scanning, saving files to the attached device, or it
is being calibrated.
• Scan functions—The icon represents the color mode and file format for the scanned image.
Scans in color at 300dpi and creates a JPG (*.jpg) file.
S U ' G
CANNER SER S UIDE
S
CANNER
Function button
Power button
Status LEDs
Scan functions
Battery LED
USB flash drive port
USB cable Memory
port card slot
Glass release
button
Battery
compartment