Sharp MD-MT877S Service Manual page 22

MD-MT877/MD-MT877C
Servo Pre-Manual Adjustment
SKIP UP
SKIP UP
SKIP UP
SKIP UP
SKIP UP
SKIP UP
SKIP UP
SKIP UP
SKIP UP
SKIP UP
SKIP UP
SKIP UP
SKIP UP
SKIP UP
SKIP UP
SKIP UP
SKIP UP
SKIP UP
SKIP UP
* When the [STOP] button is pressed in specific condition, the "TEST MODE STOP" state is set.
* If the [BASS] button is pressed in the laser ON state (with no disc or the lid open), laser power
changes as follows.
* In the specific setting display state the setting change digit changes when the [P-MODE]
button is pressed.
• In the case of the setup value two digits.
• In the case of the setup value three digits.
* In the specific state the setting changes in the range of "0h to Fh" when the [VOLUME +/–]
button is pressed.
* If the [DISP] button is pressed, the display changes as follows.
M A N U 1
: Pre-Manual Adjustment menu
PLAY
: Temperature code indication
T M P $ $
SKIP DOWN
: A signal offset (AINO) measurement
A h
SKIP DOWN
: B signal offset (BINO) measurement
B h
SKIP DOWN
: E signal offset (EINO) measurement
E h
SKIP DOWN
: F signal offset (FINO) measurement
F h
SKIP DOWN
: Laser ON (play power)
L O N P
SKIP DOWN
: AB signal level measurement (ABMAXO)
A B
SKIP DOWN
: A-ATT (focus) tentative setting
S a
SKIP DOWN
: B-ATT (focus) tentative setting
S b
SKIP DOWN
: Pit section EF signal level measurement (LPFEFO)
e f
SKIP DOWN
: Pit section adjustment COUT level setting
P C H
SKIP DOWN
: Groove section EF signal level measurement (LPFEFO)
e f
SKIP DOWN
: Groove section adjustment COUT level setting
G C H
SKIP DOWN
: TCRS signal level measurement (TCRSMIO)
T C
SKIP DOWN
: E-ATT (tracking) initial setting
S E
SKIP DOWN
: F-ATT (tracking) initial setting
S F
SKIP DOWN
: AB input level measurement (LPFABO)
a b
SKIP DOWN
: A-ATT (focus) initial setting
S A
SKIP DOWN
: B-ATT (focus) initial setting
S B
SKIP DOWN
: TCRS signal offset (TCRSO) measurement
T H
Play back Record power
BASS
1 (initial value) 10
L O N
L O N P
1st digit (initial value)
P-MODE
P-MODE
1st digit (initial value)
P-MODE
$ $ : Temperature code
: Measurement value
: Measurement value
: Measurement value
: Measurement value
: Measurement value
: ATT setting
: ATT setting
: Measurement value
: COUT level setting
: Measurement value
: COUT level setting
: Measurement value
: ATT setting
: ATT setting
: Measurement value
: ATT setting
: ATT setting
: Measurement value
Maximum power
BASS
384
R
L O N M
BASS
2nd digit
2nd digit 3nd digit
P-MODE
P-MODE
– 22 –