9. Install the engine guard and the final gear
case guard by installing the bolts, and
then tightening them to the specified
torques.
Tightening torques:
Engine guard bolt:
7.0 Nm (0.7 m·kgf, 5.1 ft·lbf)
Final gear case guard bolt:
7.0 Nm (0.7 m·kgf, 5.1 ft·lbf)
EBU07063
Differential gear oil
Checking the differential gear oil
1. Place the ATV on a level surface.
2. Remove the differential gear oil filler bolt
and check the oil level. It should be up to
the brim of the filler hole. If the level is
low, add sufficient oil of the recommend-
ed type to raise it to the specified level.
1. Differential gear oil
2. Differential gear oil filler bolt
3. Correct oil level
8-20