Changing Coolant - Yamaha YZFR1V(C) Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
1. Maximum level mark
2. Minimum level mark
3. If the coolant is at or below the
minimum level mark, remove the
brake fluid reservoir bracket bolt,
6 remove the coolant reservoir cap,
and then add coolant to the maxi-
mum level mark.
1. Brake fluid reservoir bracket bolt
1. Coolant reservoir cap
Coolant reservoir capacity (up to the
maximum level mark):
0.25 L (0.26 US qt) (0.22 Imp.qt)
CAUTION:
G
If coolant is not available, use
distilled water or soft tap water
instead. Do not use hard water
or salt water since it is harmful
to the engine.
G
If water has been used instead
of coolant, replace it with cool-
ant as soon as possible, other-
wise the engine may not be
sufficiently cooled and the cool-
ing system will not be protected
against frost and corrosion.
6-16
G
If water has been added to the
coolant, have a Yamaha dealer
check the antifreeze content of
the coolant as soon as possible,
otherwise the effectiveness of
the coolant will be reduced.
WARNING
Never attempt to remove the radiator
cap when the engine is hot.
4. Install the coolant reservoir cap,
and then install the brake fluid res-
ervoir bracket bolt.
NOTE:
ECA10470
G The radiator fans are automatically
switched on or off according to the
coolant temperature in the radia-
tor.
G
If the engine overheats, see page
6-46 for further instructions.
Changing the coolant
WARNING
Never attempt to remove the radiator
cap when the engine is hot.
EWA10380
EAU33030
EWA10380