Mounting The Module; Install The Antenna; Connecting The Starter Disable; Connecting The Dome Light Supervision - Ultra Start 640 Series Install Manual

INSTALL GUIDE
Recommended Installation Procedures
Before Staring the Installation:
- Discuss the optional system features with the customer.
- Take a few minutes to review the installation and owners manuals.
- Do a walk around the vehicle and check for any damage.

Mounting the Module

Never mount the module in the engine compartment. Select a location under
the dash to install the main module. Be certain that the module is securely
attached and does not obstruct any serviceable areas. Mount the module so
that it cannot be seen if looking under the dash as it could be easily unplugged
by a thief. The module must be free from all moving parts such as brake,
clutch and gas pedals linkages.
Installing The Antenna
The antenna should be mounted in the top center of the windshield with the
antenna mast facing downwards. First ensure that the glass is clean and dry,
remove the plastic from the adhesive tape then press against the glass.

Connecting The Starter Disable

This system contains a built-in Starter disable relay. The brown starter kill wire
from the wire harness bag will connect to the module as normally connected.
(87a & 30) Cut the brown wire in half, then locate the vehicles starter wire. This
wire will switch to 12volts in the crank/start position only. Cut this wire in half
and confirm that the vehicle will not start. Connect the brown wires, one to
each side of the cut starter wire. Route the brown wires to the main module and
connect.

Connecting The Dome Light Supervision

This output can be used to activate the interior lights upon disarming the alarm,
connect this output to a relay to activate the interior light. The dome light output
will stay active for 30 seconds upon disarm.

Mounting The Siren

Choose a location in the engine compartment that is away from high sources of
heat and direct exposer to water. The siren should be mounted as well as
grounded to solid metal. Run the wiring for the siren so that it can not be seen
or reached from below the vehicle.
PAGE 4