Ultra Start 1271M series Install Manual page 11

PAGE 11
Step 1 - Connect All Of the Following Wires
Main Connector
YELLOW
Starter Output - 12volts during start position only.
GREEN
Heater/Acc Output - 12volts in the accessory position off during
RED
12volt 30amp Input - 12volts from ignition harness or battery.
RED
12volt 30amp Input - 12volts from ignition harness or battery.
BLUE
Ignition Output - 12volts in the ignition, start and run positions.
WHITE*
Selectable Output - Selectable Output for vehicles that may
Auxiliary Connector
BLACK
WHITE
GRN/WHT
BLUE/WHT
PINK
BLK/WHT**
GREEN***
or Door pin Input - Connect to (-) wire when door open
PURPLE***
(6pin)
System Ground Input - Connect to Chassis Ground.
Park Light Output - Connect to Park Light system.
Hood Pin Input - Connect to the Hood Pin Safety Switch.
Tach Input - Connect to A/C Tach source. (Above 2 volts AC)
Brake Switch Input - Connect to 12volts when the brake
Park Brake Switch - Connect to Park Brake
Door pin Input - Connect to (+) wire when door open
start and 14volts during run.
require a 2nd Ignition, Accessory or Start.
(14pin)
pedal is applied.
*See jumper selector position (page 7).
**MUST BE CONNECTED.
***Connect only ONE of the door input wires.
INSTALL GUIDE