Ultra Start 1250 SERIES Install Manual page 7

REMOTE VEHICLE STARTER
Wiring Diagram auxiliary connectors
* The centre pin of the keyless entry harness is not to be used for anything besides
plug-in devices such as the VP-1, DL-3, DL-7 and Data Bus Modules. Overloading
this output will damage the remote starter.
(-) 500ma Output
Door lock module output only*
(-) 500ma Output
ACTIVE RF ANTENNA**
**The antenna MUST be connected for the system to operate
*Temperature Sensor (LT Models Only)
*Input Trigger To Start 1350 Series
*Not available on 1250 Series
(-) When Running
(-) 250ma Output
Low Current (-) Output
(-) 250ma Output
Low Current (+) Output
(+) 500ma Output
Output on White wire
Second Starter
Second Accessory
Second Ignition
The jumpers control the output from the WHITE wire on the 6- pin harness. This is an
30amp relayed output. Place the jumpers in the following order to change the output.
If the jumper is in position #1 the output on the white wire will be 2nd Starter
If the jumper is in position #2 the output on the white wire will be 2nd Accessory
If the jumper is in position #3 the output on the white wire will be 2nd Ignition
*The factory default setting of the selectable output jumper is position #3.
Door lock output
Door unlock output
Status Led's
Jumper position
Position 1
Position 2
Position 3
INSTALLATION MANUAL
Green
Red
Blue
Program Button
White/Violet
Black
Red
1 2 3
Page 7
1
2
3
1
2
3
4
1
2
1
2
3
Jumpers