Receiving Traffic Announcements; Using Pty Functions - Pioneer DEH-P3100UB Operation Manual

Operating this unit
Using Auto PI Seek for preset stations
When preset stations cannot be recalled, the
unit can be set to perform PI Seek during pre-
set recall.
! The default setting for Auto PI Seek is off.
Refer to Switching Auto PI Seek on page 29.
Limiting stations to regional
programming
When AF is used, the regional function limits
the selection of stations broadcasting regional
programs.
1 Use MULTI-CONTROL to select
REGIONAL in the function menu.
2 Press MULTI-CONTROL to turn the re-
gional function on.
# To turn off, press MULTI-CONTROL again.
Notes
! Regional programming and regional networks
are organized differently depending on the
country (i.e., they may change according to
the hour, state or broadcast area).
! The preset number may disappear from the
display if the tuner tunes in a regional station
which differs from the originally set station.
! The regional function can be turned on or off
independently for each FM band.

Receiving traffic announcements

TA (traffic announcement standby) lets you re-
ceive traffic announcements automatically, no
matter what source you are listening to. TA
can be activated for both a TP station (a sta-
tion that broadcasts traffic information) or an
enhanced other network's TP station (a station
carrying information which cross-references
TP stations).
1 Tune in a TP or enhanced other net-
work's TP station.
TP indicator lights.
2 Press TA/NEWS to turn traffic an-
nouncement standby on.
# To turn off, press TA/NEWS again.
3 Use MULTI-CONTROL to adjust the TA
volume when a traffic announcement be-
gins.
The newly set volume is stored in memory and
recalled for subsequent traffic announce-
ments.
4 Press TA/NEWS while a traffic an-
nouncement is being received to cancel the
announcement.
The tuner returns to the original source but re-
mains in the standby mode until TA/NEWS is
pressed again.
Notes
! You can also turn this function on or off in the
menu that appears by using
MULTI-CONTROL.
! The system switches back to the original
source following traffic announcement recep-
tion.
! Only TP and enhanced other network's TP sta-
tions are tuned in during seek tuning or BSM
when TA is on.

Using PTY functions

You can tune in a station by using PTY (pro-
gram type) information.
Searching for an RDS station by PTY
information
You can search for general types of broadcast-
ing programs, such as those listed in the fol-
lowing section. Refer to the next page.
1 Use MULTI-CONTROL to select
PTY SEARCH in the function menu.
2 Press MULTI-CONTROL to display the
setting mode.
Section
02
13
En