Page 2
WARNINGS should solid ice be forced off the liner. Solid ice It is most important that this instruction book should be retained with the appliance for future reference. Should should be allowed to thaw when defrosting the the appliance be sold or transferred to another owner, or appliance.
Page 3
INSTALLATION If this appliance featuring magnetic door seals is to Assembly instructions replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock Fitting the decor panel (Fig. 1) unusable before you discard the old appliance. This will Fig.
Page 4
Left hand door opening Fig. 6 Fig. 4 Air is taken in through the Remove the ventilation grille upper right at the bottom of screw and pivot. the appliance, but Straighten the an air outlet safety washer (4) “gap”, measuring of the lower right 50 mm deep by hinge.
Page 5
Operation Butter and cheese: these should be placed in special airtight containers or wrapped in aluminium foil or Insert the plug into the wall socket. polythene bags to exclude as much air as possible. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O»...
Page 6
Positioning the door shelves Defrosting To permit storage of food packages of various sizes, Frost is automatically eliminated from the the door shelves can be placed at different heights. evaporator of the refrigerator compartment every To make these adjustments proceed as follows: time the motor compressor stops, during normal use.
MAINTENANCE Unplug the appliance before carrying out any Interior light maintenance operation. The light bulb inside the refrigerator compartment can be reached as follows: Warning unscrew the light cover securing screws; This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore unhook the moving part by pressing it as shown only be carried out by authorized technicians.
Need help?
Do you have a question about the FKE 167-4 and is the answer not in the manual?
Questions and answers