MULTIQUIP Whiteman WM-70S Operation Manual page 25

WM-70 PLASTER/MORTAR MIXER — START-UP PROCEDURE
4. Turn the engine switch (Figure 14) to the ON position.
Figure 14. Engine ON/OFF Switch
The main start/stop switch located on the engine cover
5.
is (Figure 15) is used to start and stop the engine. Pull
this switch outward to start the engine.
Figure 15. Start/Stop Switch (gasoline engine)
6. Place the belt slip lever (Figure 16) in the START/
STOP (disengaged) position.
Figure 16. Belt Slip Lever
(Start/Stop Position)
WM-70 PLASTER/MORTAR MIXER — OPERATION MANUAL — REV. #1 (08/09/04) — PAGE 25
CAUTION CAUTION
CAUTION CAUTION CAUTION
Make certain the drum lock pin (Figures 17 and 18) is
placed to the RIGHT (when viewing the mixer from the
towpole end) of the drum stop block which is welded to
the front side of the drum. Also make sure lock pin is
fully engaged (locked). This will prevent the drum from
tipping.
Figure 17. Drum Lock Pin (Side-View)
Figure 18. Drum Lock Pin (Right Position)
7. Pull the starter grip (Figure 19) lightly until you feel
resistance, then pull briskly. Return the starter grip
gently.
Figure 19. Starter Grip
Preventing Drum Tipping