Table of Contents
Advertisement
PAGE 9
SYSTEM RESET
SYSTEM PROGRAMMING - Menu 1
This connector is used when installing the optional keyless entry feature. If the door
lock type of the vehicle is not negative see the following pages for the appropriate door
lock diagram.
Pin 1- Green Wire- Negative Lock Output
Connect to lock wire from the switch on vehicles with a negative type switch.
**LOW CURRENT ONLY**
Pin 2- 12volt Output for Door Lock Module
This output will supply 12volts for a plug-in type door lock module. Do not use this input
to power-up relays **LOW CURRENT ONLY**
Pin 3- Blue Wire- Negative Unlock Output
Connect to lock wire from the switch on vehicles with a negative type switch.
**LOW CURRENT ONLY**
SYSTEM RESET
1 - Cycle the Ignition Key On/Off On/Off On (Leaving the key ON)
2 - Press and RELEASE the Program Switch 1 time.
(HORN will chip to confirm program mode entered)
3 - Press and HOLD the Program Switch for until the HORN HONKS 3 times.
4 - Turn ignition key OFF to exit.
ENTERING REMOTE PROGRAM MODE
1 -
2 -
1 HONK confirms program mode entered followed by
3 -
3 HONK confirming that the system has reset.
3 PIN KEYLESS CONNECTOR
Cycle the Ignition Key - ON/OFF ON/OFF ON
(Leaving the key ON)
Press and release the program switch (The HORN will HONK)
**If the HORN does not HONK repeat step 1-2.
Hold the program switch until the HORN HONKS 3 times.
KE-6
INSTALL MANUAL
Advertisement
Table of Contents
