Entering Program Mode - Ultra Start KE-6 Install Manual

KE-6
INSTALL MANUAL
NEGATIVE OUTPUT FOR LOCK
12+ OUTPUT FOR DOOR LOCK MODULE
NEGATIVE OUTPUT FOR UNLOCK
FOR MORE DETAILED INFORMATION ON PROGRAMMING, WIRING DIAGRAMS, DOOR LOCK

ENTERING PROGRAM MODE

1 - Cycle the Ignition Key On/Off On/Off On (Leaving the key ON)
2 - Press and release the Program Switch 1 time.
HORN will chip to confirm program mode entered
3 - Select the Program Menu by pressing...
Press Lock
The HORN will HONK to confirm that the system is in MENU 1
Continue to step 4.
Press Unlock
The HORN will HONK to confirm that the system is in MENU 2
Continue to step 4.
4 - Press and Release the Switch to advance through the settings.
(Confirmed by HORN HONK & LED flashes)
5 - Press and hold the Program Switch to change the setting.
(Confirmed by HORN HONK)
6 - To exit Program Mode, turn key off.
(Confirmed by Long HORN HONK)
3 PIN KEYLESS CONNECTOR
CONFIGURATION AND OTHER INFORMATION, PLEASE VISIT
WWW.ULTRASTARTERS.COM
SYSTEM PROGRAMMING - Menu 1
SYSTEM WIRING
GREEN
RED
BLUE
PAGE 8