Table of Contents
Advertisement
PAGE 5
TRANSMITTER PROGRAMMING
SYSTEM PROGRAMMING - Menu 1
TRANSMITTER PROGRAMMING
The system can lean up to 4 different remote's. Each remote to be used MUST be programmed
together during the same sequence. For security, when a new remote is programmed all
previous remote's are deleted. Please see remote operation chart for information on using
Second Car / Pad Lock Operations
ENTERING REMOTE PROGRAM MODE
Cycle the Ignition Key - ON/OFF ON/OFF ON
1 -
(Leaving the key ON)
Press and HOLD the valet switch, HORN will HONK ONCE
2 -
(If HORN does not HONK repeat step 1)
CONTINUE TO HOLD until HORN HONK 5 times
1 HONK confirms program mode entered followed by
3 -
5 HONK confirming transmitter program mode
PROGRAMMING REMOTE'S
Press & Release LOCK button on 1st Remote to be
4 -
Programmed for Normal Operation If remote(s) are to be
programmed for "PADLOCK" skip and goto step 6
HORN will HONK 1 time to confirm remote has been
5 -
programmed (If HORN does not HONK press button again)
REPEAT STEP 4 IF A SECOND REMOTE IS TO BE PROGRAMMED FOR NORMAL OPERATION
Press & Release BUTTON 4 on Remote to be Programmed for
6 -
2ND CAR OR PAD LOCK
HORN will HONK 1 time to confirm remote has been
7 -
programmed (If HORN does not HONK press button again)
REPEAT STEP 6 IF A SECOND REMOTE IS TO BE PROGRAMMED FOR 2ND CAR / PADLOCK OPERATION
Turn ignition key OFF to exit remote program mode when all
8 -
required remote's have been programmed.
NOTE: ALL REMOTE'S TO BE USED MUST BE PROGRAMMED IN SEQUENCE
WHILE IN REMOTE PROGRAM MODE, RE-ENTERING REMOTE PROGRAM MODE
WILL ERASE ALL PREVIOUS REMOTE'S
.
KE-6
INSTALL MANUAL
Advertisement
Table of Contents
