1. Manuals
  2. Brands
  3. Ultra Start Manuals
  4. Automobile Electronics
  5. KE-6
  6. Install manual

Ultra Start KE-6 Install Manual

Advanced keyless entry system
Hide thumbs Also See for KE-6:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Owner's Manual
KE-6
REV.2009.04.10
A
K
E
S
DVANCED
EYLESS
NTRY
YSTEM
TM
INSTALL GUIDE
www.ultrastarters.com
FCC ID NOTICE
This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions:
1. This device may not cause harmful interference, and
2.This device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the part responsible for compliance void the user's authority to operate
this devise.

Advertisement

Table of Contents
loading

Related Manuals for Ultra Start KE-6

Summary of Contents for Ultra Start KE-6

  • Page 1 KE-6 REV.2009.04.10 DVANCED EYLESS NTRY YSTEM INSTALL GUIDE www.ultrastarters.com FCC ID NOTICE This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions: 1. This device may not cause harmful interference, and 2.This device must accept any interference received, including interference that may cause undesired operation.

  • Page 2: Table Of Contents

    KE-6 PAGE 2 INSTALL MANUAL SYSTEM PROGRAMMING - Menu 1 TABLE OF CONTENTS Wire Diagram..............Page 3 Quick View Programing Chart........Page 4 Program Menu 1 Page 4 Program Menu 2 Page 4 Transmitter Programming..........Page 5 System Wiring..............Page 6-9 10 Pin Connector...

  • Page 3: Wire Diagram

    KE-6 PAGE 3 WIRE DIAGRAM INSTALL MANUAL SYSTEM PROGRAMMING - Menu 1 POSITIVE PARK LIGHT OUTPUT (+15amp) WHITE SYSTEM CHASSIS GROUND INPUT BLACK CONSTANT 12 VOLT INPUT (20AMP) OUTPUT TO ACTIVATE SIREN (+) 2amp BROWN OUTPUT FOR TRUNK RELEASE (-)

  • Page 4: Quick View Programing Chart

    KE-6 PAGE 4 INSTALL MANUAL SYSTEM PROGRAMMING - Menu 1 QUICK VIEW PROGRAM CHART ENTERING PROGRAM MODE To Enter Program Mode 1 - Cycle the Ignition Key On/Off On/Off On (Leaving the key ON) 2 - Press and release the Program Switch 1 time.

  • Page 5: Program Menu

    KE-6 PAGE 5 TRANSMITTER PROGRAMMING INSTALL MANUAL SYSTEM PROGRAMMING - Menu 1 TRANSMITTER PROGRAMMING The system can lean up to 4 different remote’s. Each remote to be used MUST be programmed together during the same sequence. For security, when a new remote is programmed all previous remote’s are deleted.

  • Page 6: System Wiring

    KE-6 PAGE 6 INSTALL MANUAL SYSTEM PROGRAMMING - Menu 1 SYSTEM WIRING 10 PIN CONNECTOR OUTPUT TO ACTIVATE SIREN (+) 2amp BROWN OUTPUT FOR TRUNK RELEASE (-) GRAY OUTPUT TO ACTIVATE HORN/ AUX (-) WHT/BLUE STARTER DISABLE (-) WHEN LOCKED...
  • Page 7 KE-6 PAGE 7 SYSTEM WIRING INSTALL MANUAL SYSTEM PROGRAMMING - Menu 1 Pin 1- Brown Wire- SIREN Output (+) (2amp Maximum) Connect this wire for optional siren activation. Pin 2- Grey Wire- Trunk Release/Auxiliary Channel 2 (-250ma Output) This output activates for 0.75 sec when the unlock button is held for 5 seconds.

  • Page 8: Entering Program Mode

    KE-6 PAGE 8 INSTALL MANUAL SYSTEM PROGRAMMING - Menu 1 SYSTEM WIRING 3 PIN KEYLESS CONNECTOR GREEN NEGATIVE OUTPUT FOR LOCK 12+ OUTPUT FOR DOOR LOCK MODULE NEGATIVE OUTPUT FOR UNLOCK BLUE FOR MORE DETAILED INFORMATION ON PROGRAMMING, WIRING DIAGRAMS, DOOR LOCK CONFIGURATION AND OTHER INFORMATION, PLEASE VISIT WWW.ULTRASTARTERS.COM...

  • Page 9: System Reset

    KE-6 PAGE 9 SYSTEM RESET INSTALL MANUAL SYSTEM PROGRAMMING - Menu 1 3 PIN KEYLESS CONNECTOR This connector is used when installing the optional keyless entry feature. If the door lock type of the vehicle is not negative see the following pages for the appropriate door lock diagram.
  • Page 10 KE-6 PAGE 10 INSTALL MANUAL SYSTEM PROGRAMMING - Menu 1 PROGRAMMING STEP 1 - ENTER PROGRAM MODE MENU 1 1 HONK Cycle the Ignition Key HORN will chip to confirm Press Lock Button on Press and release the ON/OFF ON/OFF ON...

  • Page 11: System Programming

    KE-6 PAGE 11 PROGRAMMING INSTALL MANUAL SYSTEM PROGRAMMING - Menu 1 SETTING 4- DOOR LOCK TIMING PRESS 4 HONK THE HORN WILL HONK 4 TIMES WHEN SETTING 4 IS SELECTED 4 TIMES CHANGE SETTING 4 - PRESS & HOLD THE VALET SWITCH UNTIL THE HORN HONK(S) GOTO SETTING 5 - PRESS &...
  • Page 12 KE-6 PAGE 12 INSTALL MANUAL SYSTEM PROGRAMMING - Menu 1 PROGRAMMING STEP 1 - ENTER PROGRAM MODE - MENU 2 1 HONK Cycle the Ignition Key HORN will chip to confirm Press Unlock Button on Press and release the ON/OFF ON/OFF ON...

  • Page 13: System Programming

    KE-6 PAGE 13 QUICK VIEW CHART INSTALL MANUAL SYSTEM PROGRAMMING - Menu 1 HONK / BUTTON BUTTON PRESS SYSTEM FUNCTION FLASH 1 SEC LOCK DOORS 3 SEC ACTIVATE PANIC PRESS THEN ACTIVATE CONSTANT LOCK RELEASE THEN OUTPUT ** LOCK PRESS & HOLD...
  • Page 14 KE-6 PAGE 14 INSTALL MANUAL SYSTEM PROGRAMMING - Menu 1 INSTALLER NOTES INSTALLER PROGRAM OPTION CHART - PLACE A CHECK MARK BY THE OPTION PROGRAMMED PROGRAM MODE 1 SETTING # SETTING OPTION 1 OPTION 2 OPTION 3 LED FLASHES DESCRIPTION...
  • Page 15 KE-6 PAGE 15 WARRANTY INSTALL MANUAL SYSTEM PROGRAMMING - Menu 1 Applicated Security Technologies, Inc. ("AST") promises to the original purchaser to repair or replace with a comparable reconditioned model any AST control module ("module") excluding without limitation the any other accessories, including but not limited to the antenna, remote, HORN and...
  • Page 16 technical support: support@ultrastarters.com additional product information: www.ultrastarters.com...

Table of Contents