Product Identification; Assembling Heater - Vanguard MINI-HEARTH VMH2800TPC Owner's Operating & Installation Manual

PRODUCT
IDENTIFICATION
Heater
Cabinet
Figure 1 - Vent-Free Gas Log Propane/LP Gas Space Heater
UNPACKING
1. Remove heater from carton.
2. Remove all protective packaging ap-
plied to heater for shipment.
3. Make sure your heater includes two
hardware packets.
4. Check heater for any shipping damage.
If heater is damaged, promptly inform
dealer where you bought heater.
ASSEMBLY

ASSEMBLING HEATER

Tools Required: Phillips screwdriver, 5/16"
hex wrench, and slotted screwdriver
Removing Front Panel Of Heater
1. Remove two screws near bottom cor-
ners of front panel with Phillips screw-
driver.
2. Pull bottom of front panel forward, then
down (see Figure 2) .
103507
Ignitor Button
Log
Figure 2 - Removing Front Panel of Heater
Installing Log
For easier installation, lay heater on
Note:
its back.
1. Remove log from inside top of heater.
Discard protective packaging.
2. Attach ignitor cable to piezo ignitor
(see Figure 3).
3. With Phillips screwdriver, remove four
screws holding screen in place. Remove
screen.
OWNER'S MANUAL
Control Knob
Figure 3 - Attaching Ignitor Cable to Piezo
Ignitor
4.
5.
3
Lighting and
Warning Plates
Screen
Front
Panel
Piezo Ignitor
Gently slide log between log retaining
brackets on deflector assembly (see Fig-
ure 4, page 4). The log should fit firmly
against bottom of log retaining brackets.
Reattach screen using four screws re-
moved in step 3.
Ignitor
Cable
Continued