SCAMP MODELS
SELF PROPELLED
SERVICING AND ADJUSTMENTS
DRIVE ROLLER ADJUSTMENT
1. With the control handle in "Neutral", place both
2. Loosen bolt and nut located
in drive roller gap
rear wheel height adjusters in #1 (lowest) cutting adjusting slot on each side
of drive roller bracket.
position as shown. A gap of 3/16" should appear
between the
drive rollers and
tires.
3. Move the drive roller bracket
up or
down to ob-
tain the necessary 3/16'' drive roller gap. Hold
bracket in position and tighten both bolts and nuts
securely.