Advertisement
SCAMP MODELS
REPLACEMENT AND SERVICING
SELF-PROPELLED DRIVE BELT
LUBRICATION
50 HOURS
1. DRIVE ROLLER
BEARINGS-Disassemble
rotating shaft cover from self-propel mechanism by
removing four screws. Unscrew plug from end of
each drive roller (Point "A"). Fill exposed cavity with
EQUIVALENT. Replace plug and tighten until snug.
Repeat procedure until lubricant appears on cross-
shaft at Point "B". Reassemble rotating shaft cover
to self-propel assembly.
LAWN-BOY "A" GREASE, PART NO. 610726
OR
FOUR PLACES
BOLT-PULLEY-ARM-NUT
LOWER IDLER ASSEMBLY
PART #682564
LOWER IDLER PULLEY-Permanently lubricated.
No lubrication required.
FLOATING IDLER PULLEY-Do
not immerse the
idler pulley in solvent. Use a rag containing solvent,
clean the hole in the idler pulley and the shoulder
bolt thoroughly. Using a small amount of LAWN-
BOY "A" GREASE or EQUIVALENT, relubricate the
shoulder bolt and remount idler pulley assembly in
the same order it was originally.
AS REQUIRED
1. CLUTCH LINKAGE-Apply several drops of light
machine oil on clutch mechanism at all pivoting
points.
19.50
...........................SERVICE
BULLETIN REFERENCES
1983
Advertisement
