Ariens Deluxe 28 Manual page 11

Install Discharge Chute and
Discharge Chute Crank
(921023, 024, 030, 032, 035)
(Figures 10 and 11)
1. Grease underside of discharge chute
ring (if not already greased).
2. Remove mounting hardware from auger
housing (Figure 10).
3. Install discharge chute over opening in
the auger housing. Finger tighten the
mounting hardware removed in step 2.
NOTICE: Leave discharge chute pedestal
loose to help install the chute crank.
4
1. Mounting Holes
2. Discharge Chute
3. Chute Pedestal
4. Discharge Chute Ring
5. Mounting Hardware
Figure 10
4. Insert the short end of the chute crank
into the hole in the front of the control
panel.
NOTICE: Be careful not to damage nylon
bushing when attaching crank to the control
panel.
5. Connect the chute crank to the pinion
gear on chute with hairpin.
.
2
1
1. Chute Crank
2. Control Panel
3. Hairpin
2
3
6. Orient the chute and pedestal to its most
5
Install Discharge Chute, Chute
Control and Chute Rod
(921028, 029)
(Figures 12, 13 and 14)
1. Grease underside of discharge chute
2. Remove mounting hardware from auger
3. Install discharge chute over opening in
NOTICE: Leave discharge chute pedestal
loose to help install the chute rod.
EN - 11
921023, 024, 030, 032, 035
Figure 11
vertical position and tighten pedestal
hardware to 15 – 31 lbf-ft (20 – 42 N•m)
(Figure 10).
ring (if not already greased).
housing.
the auger housing. Finger tighten the
mounting hardware removed in step 2.
3
1