Table of Contents
Advertisement
MIYN46 Wall Transmitter
2.3
General safety instructions
DANGER!
!
During maintenance operations, when the MIYN46 Wall Transmitter is powered and its casing
is removed, the MIYN46 Wall Transmitter may not be left unattended.
CAUTION!
!
The MIYN46 Wall Transmitter may only be connected to the electrical sources as described in
Section 4.2 Installation, page 11.
CAUTION!
Maintenance and repairs may only be performed in accordance with the instructions and by
authorized technical personnel only. The sole possession of the User Manual US does not
!
allow the personnel to perform any kind of repair on the MIYN46 Wall Transmitter. Take into
account all the warnings and follow all the instructions displayed on the MIYN46 Wall Trans-
mitter and those which are printed in the documentation.Never try to use replacement pieces
other than those authorized by the manufacturer of the MIYN46 Wall Transmitter.
CAUTION!
!
It is mandatory to use the products specified in the present User Manual US to clean the
MIYN46 Wall Transmitter. If you plan to use another product, only do so after having obtained
the authorization of the manufacturer.
WARNING! Electro Static Discharge
The MIYN46 Wall Transmitter contains highly sensitive electronic components. It should be
opened only in an ESD protected environment with respect to the following precautions:
!
CAUTION!
!
Never let any liquid enter the system. In case of liquid spill inside the MIYN46 Wall Transmit-
ter, act immediately as follows:
1.
2.
3.
4.
2.3.1
Observation and information
In case of defective operation or any other technical incident for which no remedy is
described in this manual, please contact immediately your local representative.
2.4
Special safety instructions
Appropriate safety instructions linked to specific risks are described in the corresponding
section of this manual.
Bosch Security Systems
Discharge yourself from electrostatic loads by touching a grounded conductive surface
before opening the unit.
Avoid touching conductive parts inside the MIYN46 Wall Transmitter if not absolutely nec-
essary.
Switch off the MIYN46 Wall Transmitter: take out the battery or remove the power supply.
Dry up the MIYN46 Wall Transmitter.
Clean the MIYN46 Wall Transmitter.
Check its electrical functions.
User Manual US
Safety Instructions | en
970.035b | F.01U.278.521 | v2.0 | 2012.12
7
Advertisement
Table of Contents
