GE 21, 23, 25, 27, 29 Owner's Manual page 32

Before you call for service...
Problem
Frequent "buzzing"
sound
Ice cubes have
odor/taste
Small or hollow cubes
Slow ice cube freezing
Cube dispenser does
not work
Water has poor taste/odor
Water in first glass
is warm
Water dispenser does
not work
Water spurting from
dispenser
Water is not dispensed
but icemaker is working
No water or ice cube
production
32
Possible Causes
Icemaker power switch is in the
on position, but the water supply
to the refrigerator has not been
connected.
Ice storage bin needs cleaning.
Food transmitting odor/taste
to ice cubes.
Interior of refrigerator
needs cleaning.
Water filter clogged.
Door left open.
Temperature control not set
cold enough.
Icemaker turned off or
water supply turned off.
Ice cubes are frozen to
icemaker feeler arm.
Irregular ice clumps in
storage container.
Dispenser is LOCKED.
Water dispenser has not been
used for a long time.
Normal when refrigerator
is first installed.
Water dispenser has not been
used for a long time.
Water system has been drained.
Water supply line turned
off or not connected.
Water filter clogged.
Air may be trapped in the
water system.
Dispenser is LOCKED.
Newly-installed filter cartridge.
Water in reservoir is
frozen.
Refrigerator control setting
is too cold.
Supply line or shutoff
valve is clogged.
Water filter clogged.
Dispenser is LOCKED.
What To Do
•Set the power switch to the off position. Keeping it in the on
position will damage the water valve.
•Empty and wash bin. Discard old cubes.
• Wrap foods well.
•See Care and cleaning.
•Replace filter cartridge with new cartridge or with plug.
• Check to see if package is holding door open.
•See About the controls.
• Turn on icemaker or water supply.
• Remove cubes.
• Break up with fingertip pressure and discard
remaining clumps.
•Freezer may be too warm. Adjust the freezer control to a colder
setting, one position at a time, until clumps do not form.
•Press and hold the LOCK CONTROL pad for 3 seconds.
•Dispense water until all water in system is replenished.
• Wait 24 hours for the refrigerator to completely
cool down.
• Dispense water until all water in system is replenished.
•Allow several hours for replenished supply to chill.
• See Installing the water line.
• Replace filter cartridge or remove filter and install plug.
•Press the dispenser arm for at least two minutes.
•Press and hold the LOCK CONTROL pad for 3 seconds.
•Run water from the dispenser for 3 minutes (about
six liters).
•Call for service.
•Set to a warmer setting.
• Call a plumber.
•Replace filter cartridge or remove filter and install plug.
•Press and hold the LOCK CONTROL pad for 3 seconds.