Maintenance - Ariens Compact Track 24 Manual

TRAVELING
To travel from one work area to another:
1. 920013, 014, 021 – Press down on
handlebars enough to raise front of unit
slightly off surface.
920022 – Place the unit in the Up
(Transport) position (see Track Angle on
page 19).
2. Engage traction drive clutch without
engaging attachment clutch.
Ariens Dealers will provide any service or
adjustments which may be required to keep
your unit operating at peak efficiency. Should
engine service be required, contact an Ariens
dealer or an authorized engine
manufacturer's service center.
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
SERVICE POSITION
(Figure 20)
WARNING: Before tipping unit up
onto housing, close fuel shut-off
valve, and drain fuel tank and fuel
system so no spills will occur (see
engine manual for complete
instructions). Ensure unit is secure
and will not tip over during

maintenance.

Place unit on a flat level surface. Tip unit
forward onto front of auger housing for
service. Ensure unit is secure and will not tip
over. Strap and clamp onto bench if needed.
TRANSPORT
ALWAYS shut off engine, remove key, and
close fuel shut-off valve when transporting
unit on a truck or trailer.
Use extra care when loading or unloading
unit onto trailer or truck.
Secure unit chassis to transport vehicle.
NEVER secure from rods or linkages that
could be damaged.
DO NOT transport machine while engine is
running.
MAINTENANCE
EN - 23
Service Position
Figure 20