Zanussi ZKH7146J User Manual page 27

35°
2. Connect the other end of the inlet hose
to the back of the appliance. The inlet
hose can ONLY be turned as showed in
the picture.
Do not place the inlet hose down-
wards. Angle the hose to the left or right
depending on the position of your water
tap. Set the hose correctly by loosening
the ring nut. After positioning the inlet
hose, be sure to tighten the ring nut
again to prevent leaks.
Caution! The inlet hose must not be
lengthened. If it is too short and you do not
wish to move the tap, you will have to purchase
a new, longer hose specially designed for this
type of use.
Warning! Installation should comply
with local water authority and
building regulations' requirements.
The appliance must be connected to a
cold water supply.
A minimum water pressure of 0.05 MPa (0.5
bar) is required for safe operation of the
appliance.
If you cannot make the cold water connection
direct from the rising mains, you may be able to
operate the appliance from your cold water
storage system.
www.zanussi.com
1. Connect the ap-
propriate end of
the hose to a tap
with a 3/4"
thread. Always
use the hose
supplied with the
appliance.
45°
There should be a minimum vertical distance of
5.02 m (16.5 ft) between the appliance's inlet
and the bottom of the water storage tank.
Water drainage
This appliance is designed to be permanently
plumbed into your home's drainage system us-
ing one of the following methods.
1. Into a drainage standpipe.
Firstly form a hook in the end of the drain
hose using the "U" piece" supplied.
"U" piece supplied
Place the drain hose into your standpipe,
which should have an internal diameter of ap-
proximately 38 mm thus ensuring there is an
air break between the drain hose and stand-
pipe.
When discharging into a standpipe ensure
that the top of the standpipe is no more than
90 cm (35.4'') and no less than 60 cm (23.6'')
above floor level.
The drain hose may be extended to a maxi-
mum of 4 metres. An additional drain hose
and joining piece is available from your local
Service Force Centre. The joining piece must
have an internal diameter of 18 mm.
38 mm (1.5")
standpipe
diamater
30 cm (12")
27